2013年7月1日星期一

CA Clearomizer(changeable resistance wire) glass cover designs


CA Clearomizer(changeable resistance wire)for ego series battery
Free shopping all over the world!

Note:This clearomizer use the solid e-liquid. 

Buy now solid e-liquid  

1.Clear cartomizer system, easy to refill and clean.
2.New glass cover designs.
3. 510 Screw thread,compatible with 510, eGo,  eGo-T, eGo-W, eGO-C battery.
4. Low resistance atomizer about 1.8ohms.

Length: 65 mm
Diameter: 22 mm
Capacity: 1.0ml

High quality E-CIGARETTE VMAX V V MOD


Vmax includes:
1x Vamx multifunction body
Function of Vmax
1. Buit-in three digit display allows you to visually adjust your voltage.
2. Output Voltage: adjustable from 3.0V-6.0v in 0.1 volt increments.
3. Discharge voltage:6v-8.4v
4. Quiescent current:<100uA
5. Step-down regulator
6. Battery:stacked 2 pcs IMR Nipple 600mah 18350 battery
7. VMax can handle 5Amps or even bigger current
8. Protection against short circuit.Protection against installing the battery backwards.The mod monitor the battery voltage and automatically shuts off when the battery is discharged.

Power adjust up
1. Press the button 3 times in a row until “Uu” is shown on the display.
2. When Uu is shown on the display,leave the button ilde for 2 seconds.they display will change to show the last voltage selected.
3. Once the voltage is displayed.each time you press the button the voltage will advance to the next higher setting:3.1,3.2,3.3 etc.When you reach 6.0,it will rotate back to 3.0 and go up again.
4. When you have reached the desired settin,leave the button idle for 2 second.The setting will be saved and VV will resum normal operation.

Power adjust down
1. is shown on the display.
2. When ud is shown on the display.leave the button idle for 2 seconds.They
displaywill change to show the last voltage selected.
3. Once the voltage is displayed,each time you press the button the voltage will
advance to the next lower setting:5.9,5.8,5.7 etc,When you reach 3.0,it will rotate back to 6.0 and go up again.
4.When you have reached the desired setting,leave the button idle for 2 second.The setting will be saved and VV will resum normal operation.